CLP INTERFER CHK SOLN B4,125mL
Please Login or Register to see price.Description/ Intended use
Interference Check Solutions (ICS) are used to confirm that interfering elements likely to be encountered in environmental samples do not cause incorrect measurements of analyte concentrations.
According to the US EPA criteria, inter-element interference corrections are achieved by using Inter Element Correction (IEC) factors. These are calculated by observing the effect of known amounts of interferents on the analyte wavelengths. A table of IEC factors is generated and applied to the sample results during the analysis. In ILM04.0/05.0, two solutions are analysed - Interference Check Samples A (Ref: CLPP-ICS-A-125ML)and AB (Ref: CLPP-ICS-B-125ML), where A contains 4 interferents only (Al, Ca, Fe and Mg) and AB contains the interferents plus 16 analytes. In the ICSA, the analytes must be within ± 2xCRDL (for elements with CRDLs ³10 ug/L) and in ICSAB the analytes should be recovered within ± 20%. If the recoveries are outside these limits the “Recalibrate and Repeat with Samples” action should be conducted. For elements with CRDLs > 10 ug/L the results of the ICSA are simply reported with no test applied. The ICSA and ICSAB tests are applied at the beginning and end of the run and at a frequency of not greater than 20 samples. In Method 200.7, 17 single element, Spectral Interference Check (SIC) solutions are prepared. Concentration results at analyte wavelengths are then compared to the IDL or 3 sigma control limits of the calibration blank.
Product Specifications
-
Part #:
CLPP-ICS-B4-125ML
-
Description:
CLP INTERFER CHK SOLN B4 125mL
-
Matrix:
5% v/v Nitric Acid
-
Dilution:
1:100
Every Inorganic Ventures CRM is sold in patented TCT packaging giving your product up to 3 years shelf life. Read more...
-
- Analyte
- µg/mL
-
- Sb
- 60
-
- As
- 10
-
- Ba
- 50
-
- Be
- 50
-
- Cd
- 100
-
- Cr
- 50
-
- Co
- 50
-
- Cu
- 50
-
- Pb
- 5
-
- Mn
- 50
-
- Ni
- 100
-
- Se
- 5
-
- Ag
- 20
-
- Tl
- 10
-
- V
- 50
-
- Zn
- 100
Associated Certifications: ISO 17034 | ISO 17025
Only Inorganic Ventures can give you ALL of these.....
✔ Produced under ISO 17025
✔ Produced under ISO 17034
✔ Assayed by validated ICP-OES procedures
✔ Trace metallic impurities determined by ICP and ICP-MS
And up to 3 YEARS SHELF LIFE with TCT packaging